The air control unit has two filters for removing oil and moisture from the compressed air and a pressure regulator for regulating the air pressure.

The unit consists of precision two-stage regulators for accurate adjustment of oxygen and fuel gas pressures where continuous, high speed flow is possible.

MANIFOLD is recommended for connecting several gas cylinders together. Additional regulator is supplied for the regulation of nitrogen which is used as a carrier gas to powder feeder.

This is a group of three matched high pressure high quality, light weight flexible hoses equipped with proper fittings. 

The hoses have proper fittings at both sides to connect the control panel & gun distinctly. Initially hoses will be connected to control console and the hoses blown out at low pressure before the gun is connected.

LPG VAPORIZER is attached to the system to convert the liquefied fuel into vaporized state to get the precise combustion process.

In this system the temperature can be adjusted according to the process requirements and it leads to the accurate melting of particles.

It has been designed to control the water flow and temperature of the cooling system,

if the temperature is exceeded to a level the system will shutdown the coating process, user can find out the temperature of the cooling water by using this system.

This is an attachment to the spray gun to provide internal coatings of the bores and mould cavities. Coating can be possible in internal diameters of 200mm. Designed to withstand high temperatures.

Produces comparative coating characteristics without compromising the actual spray coating characteristics.

Extention Nozzle are avaible for HVOF, LVOF, Powder, arcspray.

Water cooled jacket is used as an attachment to the spray gun for additional cooling of the gun when the working temperatures are too high.

For uniform flow throughout the process and uninterrupted gas supply is required. Single cylinder may not fulfill the need of the coating process. 

To overcome this problem a GAS MANIFOLD is introduced to take gas from number of cylinders and sent to the gun consistently.

While coating the surface of the substrate, gets heated rapidly and this leads to interrupt the process.

In order to overcome this problem MEC introduced an Air Blast Cooling Unit to propel air on to the surface of the substrate while the spraying is in-process. This prevents overheating of the substrate.

MEC takes safety of thermal spray very seriously instead an option. All our HVOF systems are engineered and built for productive and safe operation.

MEC will strongly recommend the operator to follow the safety symbols which are affixed on each subsystem while operating the thermal sprays system.